16.06.2014, 21:42
Ok guys, So before I had an Cisco Router wich was waaay too good, but now it broked and I've replaced it.
The problem is that I don't know how how to port forward it, is like very annoying.
The new router model is: Tehnicolor 7200
In the Router Port Forwarding Zone: I have
Add Row
If I add a row, I get:
Public Port Range
Target IP Address
Target Port Range
Protocol
I press save, and when I check if the port is open, it is not!!!
Please help me
cause this is said for me.
The problem is that I don't know how how to port forward it, is like very annoying.
The new router model is: Tehnicolor 7200
In the Router Port Forwarding Zone: I have
Add Row
If I add a row, I get:
Public Port Range
Target IP Address
Target Port Range
Protocol
I press save, and when I check if the port is open, it is not!!!
Please help me
cause this is said for me.
