13.12.2015, 17:17
Are you using CreateDynamicObject?
The water level is same in SA:MP and MTA, the problem you are having is weather ID for "water" level. Some weather IDS have bigger waves some smaller which gives impression that the water level is higher than it should.
Also while inside the editor, the water level will remain lower from which it is, therefore that could also cause impression that there is difference between sa:mp & mta default water level. Its better to map stuff way above water, like interiors so therefore you wont have those problems.
The water level is same in SA:MP and MTA, the problem you are having is weather ID for "water" level. Some weather IDS have bigger waves some smaller which gives impression that the water level is higher than it should.
Also while inside the editor, the water level will remain lower from which it is, therefore that could also cause impression that there is difference between sa:mp & mta default water level. Its better to map stuff way above water, like interiors so therefore you wont have those problems.