25.05.2011, 09:14
(
Последний раз редактировалось X3nZ; 25.05.2011 в 09:57.
)
Continued -
Screw several holes into the center of the glass so the fan can get ventilation, and then 4 screws at the end of the corners, latching the fan and guard to the glass.
Repaint the exterior of the side panel, flat black again, and the interior both because I've missed a couple spots as you can see, then to clean up and finish the project.
Quote:
|
Step 2 (Cutting the glass to fit in the inside of the panel, which is done, see Step 2.1):  Step 2.1 (I have cut the glass and it fits perfectly into its place): -As you can see, the guard is on the outside of the glass which will be shown on the outside when the panel is back on   |
- Conclusion
Screw several holes into the center of the glass so the fan can get ventilation, and then 4 screws at the end of the corners, latching the fan and guard to the glass.
Repaint the exterior of the side panel, flat black again, and the interior both because I've missed a couple spots as you can see, then to clean up and finish the project.