[X3nZ]

Alright, so to begin with...

This is a case modification that I decided out of the blues to do. At the beginning of this 'mod' I thought it turn out bad and because this is my first time doing so, I didn't think I would of done a good job, which on the side panel cutting part, I used a jigsaw to cut the center piece out and before I sanded the edges down, it look worse then what it did in the pictures..

System specs (Not the best but satisfies me until I get my new computer):
CPU: AMD 8450 Phenom II X3 2.1 GHZ
GPU: ATI Radeon HD 4550 512MB
PSU: 450 Watts (I forget the manufacture)
RAM: A-DATA 1033 2GB (2 x 240 Pin)
HDD: Seagate Barracuda 120 GB
Motherboard: GIGABYTE M68M-S2P
DVD Drive: LITE-ON Combo USE External Drive

Case: White Standard Full Tower Case, by AMD.
The case costed me nothing because my ex-step dad gave it to me, and it looked like shit, as you can see in the pictures, I had no interest in cleaning it. Which I did clean it before I painted it.

• The Process

-What the case looked like before I did anything to it:

Quote:

-Then I decided to paint the exterior of the case:

Quote:

-Then the interior of the case, which is red:

Quote:

-Here is where the major modification to it begins, putting the plexi-glass into the side panel

Quote:

Step 1 (Cutting the center piece of the side panel, where the glass will show):

Continue to post two!