router xD..................
#1

i forget my router pass so how can i get to defult my router pass is there any way to chnag i try to reset button on router but it didn't chnag is there any way to know what is my pass and how can i chnag to defult router pass? my router model is Zyxel 206m1r
pls tell me this is my important
Reply
#2

You have changed it? Default could be "1234", "Admin" or "Password"
Try hold "reset" button down like 10 sec?
Anyway i found this:
Quote:
Originally Posted by Zyxel Site
Problem:
Users forget system password. What should users do to reset it to default?

Solution:
The only solution is to reset the password to default '1234' by resetting the whole router configurations. One is to push the hardware reset button. The other soultion is to reset the settings you need to upload our default configuration file (*.rom). Please read through the following steps to do it.(The device must contain serial console port ) 1. Connect your router to PC's serial port 2. Start a terminal program with 9600bps, N81 settings 3. Power on the router you should see the power up message on the Terminal screen 4. Enter 'Debug Mode' during router power on 5. Type 'ATSH' to check the current firmware version 6. Download the above firmware zip from our FTP site or ask it from the local distributor if it is not on our web/ftp. 7. Extract the *.rom file in the zip to your hard disk 8. Type 'ATUR3' command in debug mode to start to upload the *.rom file 9. To send file, please select the file transfer function in terminal program to start it. 10. Use X-Modem as protocol to send file. 11. Enter ATGO to start up the router
Reply
#3

lol i had the same problam with my belkin router... just keep reseting.. then eventually it would work maybe.
Reply
#4

i also reset that router button but its didn't work
Reply
#5

is there any easy way to get my defult router pass or any software?
Reply
#6

try USERNAME : admin and pass admin
Reply
#7

i try but its not working is there any software have to show my password?
Reply
#8

Try installing the Router software again.
Reply
#9

i didn't install any router software its auto detected
Reply
#10

Try Using Username:admin Password:admin

If that didn't work there should be a reset button on any side there will be a small hole so you have to use a small Stick Then Hold on Pressing...

If that didn't work please tell me what router you have.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)