Creating pickups on SA-MP objects, in SA boundaries. - Printable Version

+- SA-MP Forums Archive (https://sampforum.blast.hk)
+-- Forum: SA-MP (https://sampforum.blast.hk/forumdisplay.php?fid=3)
+--- Forum: Bug Reports (https://sampforum.blast.hk/forumdisplay.php?fid=20)
+--- Thread: Creating pickups on SA-MP objects, in SA boundaries. (/showthread.php?tid=579633)

---

Creating pickups on SA-MP objects, in SA boundaries. - Crayder - 28.06.2015

Ok. So I've creating exactly 10 pickups on the Matite tubes. 7 of those pickups stayed where I put them. 3 of the others went down to the ground Z (actually they were all 10 above water). All 10 pickups were type 14 (vehicle pickup). All 10 were the armour model so I could see them, they are going to be the blank model so I need to make sure they are going to be on the tubes...

---

Re: Creating pickups on SA-MP objects, in SA boundaries. - Crayder - 28.06.2015

Update: I noticed it may only happen when the pickup is less than ~15 units above any water surface. Even if the water is below some other object, the pickup goes to the water, not the object above it.

---

Re: Creating pickups on SA-MP objects, in SA boundaries. - Evocator - 29.06.2015

This also apply to checkpoints. I had faced that before.

---